Add to Chrome
Add to Firefox
Add to EdgeD. Y. L. Ranasinghe
A Novel Algorithm for Digital Lithological Mapping-Case Studies in Sri Lanka's Mineral Exploration
Apr 01, 2024
Conventional manual lithological mapping (MLM) through field surveys are resource-extensive and time-consuming. Digital lithological mapping (DLM), harnessing remotely sensed spectral imaging techniques, provides an effective strategy to streamline target locations for MLM or an efficient alternative to MLM. DLM relies on laboratory-generated generic end-member signatures of minerals for spectral analysis. Thus, the accuracy of DLM may be limited due to the presence of site-specific impurities. A strategy, based on a hybrid machine-learning and signal-processing algorithm, is proposed in this paper to tackle this problem of site-specific impurities. In addition, a soil pixel alignment strategy is proposed here to visualize the relative purity of the target minerals. The proposed methodologies are validated via case studies for mapping of Limestone deposits in Jaffna, Ilmenite deposits in Pulmoddai and Mannar, and Montmorillonite deposits in Murunkan, Sri Lanka. The results of satellite-based spectral imaging analysis were corroborated with X-ray diffraction (XRD) and Magnetic Separation (MS) analysis of soil samples collected from those sites via field surveys. There exists a good correspondence between the relative availability of the minerals with the XRD and MS results. In particular, correlation coefficients of 0.8115 and 0.9853 were found for the sites in Pulmoddai and Jaffna respectively.
Single-target mineral detection with site-specific endmember extraction for survey points identification: A case study of Jaffna, Sri Lanka
Sep 06, 2021As field surveys used for manual lithological mapping are costly and time-consuming, digital lithological mapping (DLM) that utilizes remotely sensed spectral imaging provides a viable and economical alternative. Generally, DLM has been performed using spectral imaging with the use of laboratory-generated generic endmember signatures. To that end, this paper proposes generating a single-target abundance mineral map for DLM, where the generated map can further be used as a guide for the selection or avoidance of a field survey. For that, a stochastic cancellation-based methodology was used to generate a site-specific endemic signature for the mineral in concern to reduce the inclusive nature otherwise present in DLM. Furthermore, a soil pixel alignment strategy to visualize the relative purity level of the target mineral has been introduced in the proposed work. Then, for the method validation, mapping of limestone deposits in the Jaffna peninsula of Sri Lanka was conducted as the case study using satellite-based spectral imaging as the input. It was observed that despite the low signal-to-noise ratio of the input hyperspectral data the proposed methodology was able to robustly extract the rich information contained in the input data. Further, a field survey was conducted to collect soil samples of four sites chosen by the proposed DLM from the Jaffna peninsula as an algorithm validation and to demonstrate the application of the proposed solution. The proposed abundance threshold of 0.1 coincided with the industrial standard X-ray diffraction (XRD) threshold of 5% for the mineral presence. The results of the XRD test validated the use of the algorithm in the selection of sites to be surveyed, hence could avoid conducting a costly field survey on the assumption of the existence of a mineral.
Transmittance Multispectral Imaging for Reheated Coconut Oil Differentiation
Aug 28, 2021
Multispectral imaging systems (MISs) have been used widely to analyze adulteration and toxin formation in oil, yet a dearth of attention has been tendered to oil reheating and reusing despite the consumption of such debased oil being deleterious. To that end, the paper discusses the application of MISs to estimate the 'reheat cycle count classes' (number of times an oil sample is recursively heated) and to identify 'critical classes' at which substantial changes in the oil sample have materialized. The MIS captures the transmittance spectrum of the translucent specimen as opposed to other multispectral imaging research which often measures the reflected light from opaque solid samples. Firstly, the reheat cycle count class is estimated with Bhattacharyya distance between the reheated and a pure oil sample as the input. The classification was performed using a support vector machine classifier that resulted in an accuracy of 83.34 % for reheat cycle count identification. Subsequently, to distinguish critical classes under reheating, an unsupervised clustering procedure was introduced using a modified spectral clustering (SC) algorithm. In addition, laboratory experiments were performed to ascertain the ramifications of the reheating process with a chemical analysis. The chemical analysis of the coconut oil samples used in the experiment yielded that a statistically significant change (p < 0.05) had taken place in the chemical properties with reheating and the results of the proposed SC framework were deemed to coincide with the chemical analysis results.